Home

The best way to Build a Huge Wood Speaker Cabinet

April 9, 2018

Speaker cabinets are seldom constructed using wood. When employed for speaker cabinet building solid wood will warp, split or crack. Particle board or plywood with hard-wood veneer is nearly always employed as the core has levels that can not split, warp or crack to construct speaker cabinets so long as they aren’t getting soaked. Oak veneered plywood is the solution to go — they seldom develop than 15-inches — to be utilized in your home for stereo equipment or even to get a guitar speaker cabinet, in the event that you are creating a cupboard to get a big speaker.

The tablesaw blade to 1-1/4 inch high. Tilt it to 4-5 degrees and lock down it. Slide up to the fence to within 1/3 2-inch of touching the blade and lock down it.

Slide all of the panels within the blade to cut 45-degree miters around the grain on both ends.

Run a bead of glue along all the edges that are mitered. Place the four panels on their edges, using the corners coming-together. Use pin nails to be shot by a pin nailer from both instructions through all the sides that are mitered. Shoot the nails 3/8 inch in the edge, spaced 2″ apart. 18inch need to now have 18 – by – 18inch square body

Run a bead of glue over the exterior perimeter edges of the 3/4 by-161/2 by-161/2 inch piece of plywood. Smear the glue flat by means of your finger. Stand up the speaker box on its side and spot the piece of plywood to the opening of the body. Tap it in the opening using a hammer before the face is flush with all the exterior edges of the body, in case it fits tight.

Pin nails to the edges of the plywood encounter throughout the four sides of the body. Shoot them 3/8 inch from the edge, spaced at 2″.

Place down the speaker face on the facial skin of the box and center it. Trace having a pencil round the speaker. Remove the speaker. Using a compass, attract still another circle inside the circle, 1inch smaller.

Drill a hole through the circle 2 inch bit. The suggestion of a jigsaw to the hole and minimize the inner-circle out.

Turn the box encounter-down. Insert the speaker to the cabinet in the rear. Place it centered on the hole which you just reduce out. Use an electric driver and 5/8inch screws to screw the speaker to the within of the box utilizing the holes round the within perimeter of the speaker.

Drill a-3/4 inch hole through the rear of the other 3/4 by-161/2 by-161/2 inch piece of plywood. Drill it 2″ in one corner diagonally. Thread the speaker wires throughout the hole. Insert it to the opening in the rear of the cupboard, just as you did the entrance.

Drill three holes throughout the each facet of the cupboard, 3/8 inch in the edge that is back spaced. Insert 11/4inch screws in the holes and screw them to secure the again on the cabinet.

Stretch the display tight on the very front of the speaker. Wrap the edges on the edges of the speaker box. Shoot staples every 1/2 inch around edge to secure the display to the 3/8 inch from the the perimeter of the speaker, Trim the excessive speaker material that is free off straight utilizing a utility knife.

See related