The best way to Install a Drain in a Butcher-Block Countertop

November 4, 2017

Wood counter-tops were frowned upon in the kitchen simple to injury and difficult to sanitize. Homeowners are now understanding that wood, particularly butcherblock, is more easy to sustain than some alternatives that are some common, and at least as sanitary. Burns and cuts may be sanded out as well as the entire counter-top re-finished with mineral or bees-wax oil; as are tiles and wood isn’t susceptible to breaking. Cutting through butcherblock to get a sink isn’t particularly hard, but you have to seal any cut edge to avoid moisture damage.

Protecting the Counter-Top

Beeswax and mineral oil, the most frequent sealers for butcherblock, don’t type a good coating like urethane, varnish or shellac. Sink installation needs placement marks that may scar the wood, therefore guard the whole region of the counter-top where the sink will go with several rows of masking or painter’s tape. It’s possible for you to mark on the tape, then peel it off when you’re prepared to fall in the sink. By cutting the opening, wood is exposed to dampness. Seal the cut edges using a layer of silicone that is clear, before dropping it in the opening and include a bead of silicone across the underside of the lip of the sink.

Marking Sink Placement

Sinks are typically centered on the width of the foundation cupboard of the sink. To install the sink and you require mark the middle of the sink base cabinet on the counter-top. This can be slightly difficult because you can’t look out of the butcherblock. Transfer these marks to the best one of the simplest methods to locate the center would be to mark the sides of the cupboard on the edge of the counter-top and then mark the middle between them. Drawing a line that is centered on the tape in the splash to the front-edge will make alignment easier. Sinks require roughly 1 1/2 inches of area between the again of the backsplash. the sink and Some creative sinks have strange locations for El Paso AC repair specialists, therefore constantly follow the sink manufacturer’s placement guidelines.

Working with No Template

If you’re installing an older sink, you probably don’t have the manufacturer’s template. Not to worry, as you will be told whatever you you should know know by the sink. It is possible to align the sink using the marks on the counter-top quicker should you mark the heart factors on all sides of the sink lip. Turning the sink upsidedown on the counter-top and tracing it around offers you the tough perimeter. Don’t cut round the marked line, as it is going to be too wide as well as the sink will drop through. Instead, slice the the outline 1/8 inch inside


Drill a few holes throughout the butcherblock just in the outline before cutting the sink opening. These are access openings for the jig-saw blade to to suit through. Check the diameter of the drillbit contrary to the width of the jig saw blade to make sure the holes will be big enough. Use a new wood blade on the jig-saw, and don’t drive the noticed forward forcefully, which may bend the blade and trigger crooked cuts. Cut one side of the opening go on to to the other side do the sam-e on the two sides that are remaining. Ask a helper to contain the the bottom of the area before the cut is made by you. The fat of the butcherblock can make it split off fleetingly before you complete, perhaps harming the counter-top should you cut every one of the way round the outline simultaneously.

See related